Projectiondesign cineo3+ 1080 Operation & User’s Manual

15, 14 english 15 REMOTE CONTROL ORIENT Press ORIENT left or right to cycle between desktop, ceiling, front and rear combinations. ZOOM Press the ZOOM keys to zoom the image in and out. FOCUS Press the FOCUS keys to focus the image. SHIFT Press SHIFT, then the arrow keys to shift the image up, dow…

11, 10 11 english The keypad is illuminated for operation in dark environments. Available functions are illuminated in yellow while selected (active) functions are illuminated in green. Functions that are not available are not illuminated. In addition to the various functions, 10 keys are number…

27, 26 english 27 The LAMP indicators on the keypad will turn red when lamp life expires. Change the lamp when lifetime expires. Always replace lamp with the same type and rating. The lamp includes an electronic lamp timer that is tracking the life time of the lamp. Allow lamp to …

24, 24 english NO IMAGE No connection: Check if all connections are properly made. Source off: Check if the equipment is powered on. Lamp dead: The lamp may need replacement. Check the LAMP TIME in the UTILITIES sub menu. Source hibernated: Engage the source to display and acti…

29, Projectiondesign cineo3+ 1080 TECHNICAL DATA LENSES Short fixed lens f = 16.3 mm F = 2.1 - 6.5 throw ratio (distance : width) = 0.79 : 1 throw distance = 0.5 - 2.5 m / 1.65 - 8,25 ft. horizontal shift = +/- 1% (fine adjust only) vertical shift = +/- 1% (fine adjust only) Medium fixed lens f = 23.95 mm F = 2.1 - 6.…

16, english 16 The conector panel may be illuminated by pushing the LIGHT key on the keypad. A DVI-D - Digital RGB: For a low noise computer and video image. B RS 232 control in-out: Allows for wired remote control and monitoring of many projector functions used in installation environments.…