Sunrise Medical EMERALD Workshop Manual

21, EMERALD BATTERIES & CHARGER 1. To remove the batteries, lift the seat off. 2. Remove the rear cover. 3. Undo the two velcro straps that secure the batteries. 4. Disconnect the Red & the Black battery plugs. 5. Carefully lift the batteries out. 6. Batteries, Battery Leads & Batter…

20, EMERALD SEAT STEM 1. To remove the Seat Stem.. 2. lift the Rear Cover off its velcro mount and clear of the scooter. 3. Loosen off the Seat Post securing stud. There is no need to remove it. 4. Un-hook the Securing Pin spring. 5. Before pulling the Securing Pin out, make sure the Seat Stem …

5, EMERALD Safety Whilst working on powered mobility products, it is essential to observe good working practice. Below are a series of safety guidelines and recommendations. Please note that these precautions are intended to serve only as a guide and are not intended to supersede or replace any safety…

30, EMERALD MOTOR/ELECTRONIC BRAKE ASSY. 1. A 6.00mm hex wrench is the basic tool required for undoing the four Motor Studs. 2. Some of the studs may require extra force. That may require a cranked hex key or tool. 3. Limited room may also require the use of a hex key driver tool. If the Drive …

16, Sunrise Medical EMERALD EMERALD SEATING 1. Lift the armrests up for easy ac- cess. 2. Pull the seat recline lever upwards. 3. Allow the backrest to fold flat. 4. Stand behind the seat & lift the seat swivel lever up. 5. With the seat swivel lever in the up position, carefully lift the seat assem- bly off the seat st…

7, RECOMMENDED TOOLS 1. Metric socket set. 2. Imperial socket set. 3. Hexagon wrenches, (imperial & metric). 4. 3.5 - 8mm flat screwdriver. 5. No. 0 cross-head screwdriver. 6. No. 1 cross-head screwdriver. 7. No. 2 cross-head screwdriver. 8. Metric combination spanner set 5 - 25mm …