Supermicro AW-4020C-T Operation & User’s Manual

85, Chapter 7: BIOS 7-17 L2 Cache BG Scrub Allows L2 cache RAM to be corrected when idle. Options are Disabled and various times in nanoseconds and microseconds. Data Cache BG Scrub Allows L1 cache RAM to be corrected when idle. Options are Disabled and various times in nanoseconds and micro…

15, Chapter 2: Installation 2-1 Chapter 2 Server Installation 2-1 Overview This chapter provides a quick setup checklist to get your A+ Workstation 4020C-T up and running. Following these steps in the order given should enable you to have …

27, Chapter 3: System Interface 3-3  Power Fail (not used): Indicates a power supply module has failed. This should be accompanied by an audible alarm. A backup power supply module will take the load and keep the system running but the failed module will need to be replaced. Refer …

40, Supermicro AW-4020C-T 5-8 A+ Workstation 4020C-T User's Manual Figure 5-4. Side and Top Views of DDR Installation To Install: Insert module vertically and press down until it snaps into place. The release tabs should close - if they do not you should close them yourself. To Remove: Use …

33, Chapter 5: Advanced Serverboard Setup 5-1 Chapter 5 Advanced Serverboard Setup This chapter covers the steps required to install processors and heatsinks to the H8DCE serverboard, connect the data and power cables and install add-on cards. All serverboard…

49, Chapter 5: Advanced Serverboard Setup 5-17 Wake-On-LAN The Wake-On-LAN header is desig- nated JWOL. See the table on the right for pin defi nitions. You must have a LAN card with a Wake-On-LAN connector and cable to use the Wake- On-LAN feature. Wake-On-Ring The Wake-On-Ring …