SVP CDC-8630 Quick Start Manual

4
1
4
1
4
1
3
6
2
5
122mm+-2
165mm+-2
XR9000480
Cautions
Quick Start Guide
Icon Introduction
Printer / TV Connection
        PC Connection
                                         
 
Getting Ready
Getting Ready
8630  QSG  EN   1. XR9000480    2.       3. 80P , Z ( )
Quick Start Guide
                                  Small Tip to Save You Big Headache
A digital camera is in a way very similar to a computer.  If the digital camera hangs itself during 
operation, please follow the procedures below and most likely the camera can be re-activated.
     1. Remove the batteries.
     2. Reload the batteries.
     3. Switch on the camera.
Do not try to disassemble  the camera by yourself, which may damage the camera or cause electric shock.
Do not fire the flash in a close distance (less than 1 meter); it may hurt your eyes. 
Keep the camera away from the reach of children or animals to prevent them from swallowing the batteries or small accessories. 
Stop using the camera if any kind of liquid or foreign object enter the camera. If it happens, power off the camera and contact with 
your dealer for further help. 
Do not operate this camera with wet hands; it  may cause electric shock. 
The camera may be damaged in an environment of high temperature. 
Do not use different types of batteries or new and used batteries at the same time. 
To avoid electricity leakage, please remove  the batteries  if  the camera is not in use for a long period. 
It is normal that the temperature of the camera body rises if the camera works for a long time.
    Turn On or Off the Camera
Press down the "POWER" button  to turn on the camera.
 
Repeat the way above  to turn off the camera.
Loading the Batteries
1. Power off the camera.
2. Slide out Battery Chamber Cover to open it. 
3. Load 2  AA batteries into the battery chamber following    
    the polarity indications.
4. Close the Battery Chamber Cover.
    The below symbols on the LCD Monitor are the indication of
    the battery status.
    (     ):Battery power is full.  
(     ):Battery power is half drained. Have new batteries ready. 
(     ):Battery power is drained. Replace with new batteries.  
2 pcs of AA alkaline / Ni-MH batteries are strongly 
recommended for normal operation.
The power of batteries may run off if the batteries are kept 
inside the camera for a long time without using. Please 
remove the batteries when the camera is not in use.
Do not use manganese batteries which they cannot supply
sufficient power to support the operation of the camera.  
Batteries may not work normally under 0 C or over 40 C .
It's normal that the temperature of the camera rises after 
used for a long period.
+
Positive
-
Negative
MODE
POWER
Basic Photography
 
1. Press down the POWER button to turn on the camera.
3. Use TELE/WIDE Buttonto zoom in and zoom out. 
4. Press the shutter button half way to do the focusing and then press the shutter button fully down to capture an image. 
5. The LED Indicator starts blinking right after the Shutter Button is released.  Once the LED Indicator stops blinking, you are     
     ready to take another shot.
6. 
Or you can press Playback Button (     ) to review the images or movie clips you just took.
2. Set  the Mode Button at  Image Shooting Mode (      ) for still image, Digital Music Player (      ) for digiatal music playing and
    Movie Clip Mode  (      ) for   video recording.
    
Blinking
6
4
1
2
5
100-0021
3
2626
8M
Icon Display
 Battery Status
(    )Battery Full
(    )Battery Half 
       Drained
(    )Battery Drained
 Working Mode
(    )Image  ModeShooting 
(    )Night Scene Mode
(    )Photo Frame Mode
(    )Movie Clip Mode
(    )Voice Recording 
       Mode
1
2
  Flash Mode
(  
  )
Auto Flash
(  
  )
Auto Flash with 
       Red-eye Reduction
(    )Slow Sync 
(  
  )
Fill-in Flash  
(    )Flash Off
4
 Self-timer
(    )10 Seconds
(    ) 2 Seconds
(    ) Double
2S
5
(    )Playback  Mode
 Memory Card
 
(    )
(    )Internal Memory
 White Balance
(    )Auto
(    )Daylight
(    )Cloudy
(    )Fluorescent
(    )Tungsten
(    )Sunset
(    )Custom
12
13
 Quality
(    )Super Fine
(    )Fine
(    )Normal
15
(    ) Voice Memo
 Focus Range
(    ) Macro
 Metering
(    )Spot
(    )Multi
  Exposure     0.5(    )
6
11
  Digital 
                 Zoom
(            )  5.0X 
   Zoom In / Out 
   Indicator
18
 Available Shots( 7 ) 
17
5
1
2
4
5
6
8
17
3
10
20
11
12
13
14
15
16
7
9
 Size
(      )2848x2136
(      )2560x1920
(      )2304x1728
(      )2048x1536
(      )1600x1200
16
(      )3328x2496
2626
NOR
(    ) Black & White
(    ) Normal
(    ) Sepia
(    ) RGB
 EFFECT
R
G
B
8M
X1.2X1.2
07 : 03 AM
2006/01/31
07 : 03 AM
2006/01/31
1
 Continuous Shooting
(    )Single
(    )Continuous
3
1
7
8
  (    )
Hand Shake
078  560  256  349078  560  256  349
 Sharpness
(    )Soft
(    )Normal
(    )Vivid
14
18
19
20
19
(    ) AUTO adjust
(    ) ISO=100
(    ) ISO=200
(    ) ISO=400
 ISO
9
10
 Histogram(    )
HISTOGRAM
100
AUTO
200
400
INT
Connecting the Camera to a PictBridge-supported Printer
    1. Have both of the camera and the printer power on. 
    2. Press the MENU Button to go to SETUP Mode.
    3. Go to USB and select PRINTER for printer connection.     
    4. Use the supplied USB cable to connect the camera to the 
        PictBridge-supported printer as shown above.
If the printer you have supports the interface of PictBridge, then you can have your camera connected 
with  the printer by the supplied USB cable to have the stored images print out directly.
Connect the USB/Video connector of the camera to video 
input ports of the TV set with the supplied Video/USB Cable.
Press down the LEFT or RIGHT direction Button to go to the 
next or last image for TV reviewing. 
Turn on the TV and switch the TV/Video switch to A/V mode.   
Power on the camera and then switch to the Playback Mode. 
How to Connect with a TV
Computer / Notebook Connection
Computer
 When the USB/Video Cable is in connection with the computer while the camera is on, the camera will automatically go to the                  
 PC Mode from any working mode and  turn off  TFT LCD monitor.
In this Mode, you can download images to your computer .  
 
  How to Connect with a Computer

• 
  Blaupunkt OSLOAIR

  #E7D933: OSLOAIR Instruction

  OSLOAIR, 23, blaupunkt/osloair.pdf

• 
  Chrysler 300 2013

  Chrysler Tutorial Automobile 300 2013 (#C92M5T)

  300 2013, 9, chrysler/300-2013.pdf

• 
  Taco 265

  Timer 265 Guidance, #769BPA

  265, 4, taco/265.pdf

• 
  Fronius TransSteel 2200

  Welding System TransSteel 2200 Handbook, #48O867

  TransSteel 2200, 12, fronius/transsteel-2200.pdf

• 
  Philips 13NB5602

  #NHCIIB: 13NB5602 Instruction

  13NB5602, 2, philips/13nb5602.pdf

• 
  Philips 170V9FB

  Monitor 170V9FB Reference Book, #FV73A6

  170V9FB, 79, philips/170v9fb.pdf

• 
  Philips 29PT9457

  Philips Instruction: 29PT9457 (#D7FU8S)

  29PT9457, 2, philips/29pt9457.pdf

• 
  VIORE LCD32VH65MV

  TV LCD32VH65MV Handbook, #96D556

  LCD32VH65MV, 1, viore/lcd32vh65mv.pdf

• 
  RODE Microphones PSA-1

  #13A7GD: PSA-1 Guide

  PSA-1, 4, rode-microphones/psa-1.pdf

• 
  VTech Happy Lights Bear

  Happy Lights Bear Toy - #QZY419

  Happy Lights Bear, 9, vtech/happy-lights-bear.pdf

• Search YouTube Videos for SVP CDC-8630 Device
• Search Google for SVP CDC-8630 Information
• Search Photo of SVP CDC-8630 in Google Images
• Search Twitter for SVP CDC-8630 News