Swim'n Play end deck Assembly Instructions Manual

18, WARNING LEDGE PLACEMENT ENTRY POINT VIEW FROM INSIDE THE DECK LATCH GATE POST SELF CLOSING HINGE GATE LATCH BAR 18 Using the Latch, Latch Bar and Hinges as templates, drill the holes in the locations as illustrated at the bottom. Drill a 5/32 hole for the Latch Bar and Self Clo…

6, 3 IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME 6 Position the Bottom Support Channels (long “L” shaped pieces) at the bottoms of the Posts according to the illustration below for your size deck. Note the different sizes. (The illustrations are as viewing the deck from above with the La…

3, 3 Clear out and level the ground in the location where your deck is to be installed. Use the Assembly Drawings below for reference while assembling your deck (Note: ladder can be installed on either side). During assemly please note that the ledges on the pool are to be removed where the de…

7, 7 4a IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME Where the Posts and the Bottom Support Channels join, attach Angle Support Bars. The illustrations below indicate Close-up illustrations show the proper assembly procedure for each location. Where One Angle Support Bar attach…

8, Swim'n Play end deck 8 4b IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME Where the Posts fasten to the deck, attach Angle Support Bars. The illustrations below indicate which of the Close-up illustrations at the bottom of this page and at the top of the next page show the proper assembly procedure for each locat…