Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 Manual 

88, Table 6-4 Designating drives formats (continued) ExampleFormat omnifs dir pf:\disk_1\partition_2\dataFormat disk_1\partition_2 when the origin partition was NTFS or hidden FAT. Table 6-5 lists the commands you can use for recovering files. No other OmniFS commands are supported f…

57, Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 To run GDisk32.exe 1 On the Windows taskbar, open a command window. 2 At the command prompt, type Program Files\Symantec \Ghost\GDisk32 followed by the required disk and switches. To run GDisk64.exe 1 On the Windows taskbar, open a command window. 2 At the command prompt, type Program Files\Sym…

167, Configuring firewalls This appendix includes the following topics: ■ Symantec Ghost port configuration Symantec Ghost port configuration Table D-1 lists the ports that must be open in a firewall to allow the Ghost Console and the Console client to work. Table D-1 Ghost Console and C…

52, Table 4-1 ghDplyAw32.exe command line switches DescriptionSwitch The Windows volume to scan. For example, C: or 1.1:. If necessary, you can determine this by using GhConfig32 with the /findactivewindows switch. /target Performs the evaluation step. When this switch is excluded, the retargeting st…

15, 5 Do one of the following for operations other than checking an image: ■ Select the destination hard disk or partition. ■ Select the image file. Warning: Make sure that you select the correct destination. The destination disk is completely overwritten with no chance of recovering any data. 6 Co…

177, Symantec Ghost and legacy network cards Windows 95 and 98 are plug-and-play operating systems. They reconfigure most network cards if they find an IRQ conflict. Because GhostCasting runs on a DOS level and DOS is not a plug-and-play operating system, IRQ conflicts may arise. Most…