D&R Vision Owner's Manual

12, Vision manual page:12 3.5 Input and Output connectors Every channel has the following connectors at the back of the housing. The balanced LINE input is a stereo 1/4" jack socket: Tip = hot Ring = cold Sleeve = shield The INSERT is on a stereo jack socket. Tip = return Rin…

35, Vision manual page:35 14.01 PRODUCT SAFETY This product is manufactured with the highest standards and is double checked in our quality control department for reliability in the "HIGH VOLTAGE" section. CAUTION Never remove any panels, or open this equipment. No us…

28, Vision manual page:2 8 Effect Sends All unused aux sends can be used to send signals to signal processors such as digital reverbs, effects processors, and digital delays. The aux sends are usually post-fader in order that the right balance between untreated and treated signals i…

26, D&R Vision Vision manual page:2 6 8.0 MATRIX MODULE The Vision matrix output module is capable of making a sub mix from all or some group output signals and the left/right main output signal as well as an external input. 8.1 Matrix input control section The 10 input level controls re…

20, J23=fader LEFT when automation is installed 1=ground 2=wiper 3 Top of fader J25=Automation connector Left or fader connector when no automation is installed 1=Ground 2= VCA out 3=VCA in 4=Reference voltage 5=+5 volt (dependent upon VCA type) J26=Pre Mute select LEFT …

34, Vision manual page:3 4 14.00 Conformity statement according to ISO/IEC Nr. 22 and EN 45014 Name Manufacturer :D&R Electronica Weesp b.v. Address manufacturer :Rijnkade 15B, :1382 GS Weesp, :The Netherlands declares that this product Name prod…