Factory Five Racing Type 65 Coupe Assembly Manual

241, 240 www.factoryfive.com 508-291-3443 Driver Footbox Silicone and install the front patch panel. Seats Harness  ¾” wrench, ¾” socket, ½” drill bit, drill, ratchet  Seat Harness/Fasteners Unpack the seat harnesses and hardware. …

379, 378 www.factoryfive.com 508-291-3443 Aluminum Splash guards  ⅛”, 3 / 16 ” drill bit, drill, rivet gun, silicone, caulking gun, ¾” socket, ratchet, extension, marker, clamps  Secondary body fasteners, packaged aluminum, front wheel and tire Front Wheel With the nose…

41, Factory Five Racing Type 65 Coupe 40 www.factoryfive.com 508-291-3443 Remove the rubber tubular spacer from inside the coil. Cut one full coil from the top of the spring for correct ride height setting. Cut the upper rubber spring seat so that during assembly of the kit, it will conform to the spring moun…

121, 120 www.factoryfive.com 508-291-3443 Adjust the rod ends the same number for turns for the front and rear rod ends on the lower control arm and upper control arm as required so that  If the number of turns done is the same for all control arms on one side of the suspension, an alig…

38, 37 www.factoryfive.com 508-291-3443 Lower A-arm w/bolts, brake caliper, spindle and brake rotor. Use a spring compression tool to remove the front springs or chain the spring to the chassis. Remove the three bolts that retain the struts to the top mounting plate. Slowly lower th…