3Dlabs Wildcat 4210 Operation & User’s Manual

26, 3Dlabs Wildcat 4210 20 3. Make changes to the items under Colors or Screen Area. 4. Click OK. NOTE Any changes made in the Advanced Properties dialog affects both monitors. …

29, 23 In Windows 2000 Press CTRL+ALT+DEL but do not log on to the Windows 2000 operating system. Instead, shut down the computer, and then restart into Safe Mode to choose another resolution or to reinstall the video driver software. To restart in Safe Mode: 1. Re…

34, 28 Multiview In and Out Ports These ports are two 6-pin modular jack connectors. They allow Multiview support for frame locking and rate locking of multiple computers. Genlock In Port This port is a 75-ohm male BNC connector that is used to connect to a 75-ohm coaxi…

14, 8 NOTE If the computer’s monitors do not have built-in video cables, use shielded video cables. The cables should have DVI-I connectors or 15-pin VGA connectors (with adapters) at one end for the video output port on the card, and the appropriate connectors at the o…

18, 12 To verify the default video display driver in Windows NT 4.0: 1. Go to Start » Settings » Control Panel » Display » Settings » Display Type. 2. Verify that Wildcat 4210 is listed under Display. 3. Click Cancel to close the Display Properties dialog. See Chapte…

12, 6 Static electricity can damage the components inside a computer or on a printed circuit card. To reduce the possibility of electrostatic discharge: ♦ Turn off power to the computer. ♦ Touch the metal chassis of the computer to drain off static electricit…