H3C S9500E Series Command Reference Manual

34, Examples en-GigabitEthernet 2/0/1 on the switch operating in standalone mode to IRF en-gigabitethernet 2/0/1 et 2/2/0/1 on net2/2/0/1] quit [Sysname-irf-port 2/1] port group interface ten-gigabitethernet 2/2/0/1 t 2/1] quit do shutdown set irf slot member-id mode f slot slot-numb…

20, By default, the bridge MAC address of the IRF fabric remains unchanged, even if the master leaves the IRF fabric. • Preserve for six minutes: When the master leaves, the bridge MAC address does not change within six minutes. If the master does not come back when the prese…

35, 29 mber ID of the MPU in slot 1 of switch 2 to 1 when the switch operates in IRF mode. iguration Guide . • This command is applicable to the fast recovery of the IRF fabric only. If you use this command in other cases, unknown errors may occur. Use it with caution. # Set th…

27, H3C S9500E Series • debugging IRF fabric, execute the quit command. The active MPU of the IRF fabric is reactivated and ready for outputting information. However, you cannot redirect to the the irf switch-to command. Examples # Log in to the CLI of the standby MPU in the slot of member s…

36, Index C D I M P S C chassis convert mode irf,1 D display irf,2 display irf configuration,4 display irf topology,5 display mad,6 display restricted port,8 I irf auto-merge enable,9 irf auto-update enable,10 irf domain,10 irf link-delay,11 irf link-status auto-rec…

12, ------------------------------------------------------------------------- Link neighbor Link neighbor Belong To UP 2 00e0-fc0f-8c0f -- 00e0-fc0f-8c0f T ve information show rt 2 of member switch 1 connects with IRF-port 1 of m…