FALCOM BOLERO-LT Instructions Manual

13, BOLERO-LT Hardware Description Version 1.0.0 interference with cellular systems, local RF regulations prohibit using your modem whilst airborne. 2.9 Children Do not allow children to play with your BOLERO-LT device. It is not a toy. Child…

22, BOLERO-LT Hardware Description Version 1.0.0 6.1.2 Special pin description For the IO lines that can work as input or output the corresponding output of this pin has to be set to high (with PFAL command “$PFAL,IO4.Set=high”), otherwise 0V will be measured (and the device could…

28, BOLERO-LT Hardware Description Version 1.0.0 6.2 Mounting the BOLERO-LT device The mounting location is very important, because it can affect the GPS reception quality. Consider that the GPS receiving site of the unit is with the back viewing towards the sky. The do…

3, BOLERO-LT Hardware Description Version 1.0.0 6.1.3 Buttons & LEDs ...............................................................................................26 6.1.4 SIM card interface .............................................................................................27 …

16, FALCOM BOLERO-LT BOLERO-LT Hardware Description Version 1.0.0  Casing : ➢ Fully shielded  Certifications : ➢ Fully type approved confirming with R&TTE directive. ➢ CE, FCC, PTCRB, e1,IC.  Directive : ➢ RoHS compliant.  Firmware : ➢ Embedded TCP/IP stack (inc. TCP, IP and…

21, BOLERO-LT Hardware Description Version 1.0.0 6 HARDWARE INTERFACES 6.1 6-pin connector Figure 4: View of the 16-pin connector pin assignments 6.1.1 Pin assignment on the 6-pin connector PIN NAME I/O DESCRIPTION LEVEL 1 RxA I RS232 serial interface (receive data) for direct con…