Easy Weigh LS-100 Owner's Manual

45, 41 Sensor Settings The LS-100 can use the Gap Sensor or the Peel Sensor to Sense gaps between labels. If you constantly get the error message “Gap Sensor Error,” you may need to clean the Gap Sensor Assembly; however, if you get constant label feed or “Gap S…

14, 10 Installing Labels: Once you have followed the instructions for removing labels you can install a new label roll by taking the new label roll and remove about 30 cm (approx. 12”) of labels from the backing paper of the new label roll and then do the following: 1) Place the new lab…

11, 7 The Fuse Holder contains a 1.6A 250V 20mm safety fuse. You may need a flat screw driver to open the fuse holder but make sure that the scale is unplugged from an AC source and turned off before you do this. The RS-232 Port is a DB-9 female connector that is used to connec…

62, 58 If you clean the TPH (see Maintenance section) and any of these problems persist, then it is possible that the platen may be damaged or that the TPH has been scratched or damaged. Call your Easy Weigh Dealer for service. Do not attempt to service the TPH yourself! The TPH has h…

19, Easy Weigh LS-100 15 Do’s & Don’ts Please observe the following:  Unplug and shut the scale OFF whenever you are changing the label roll or working in the printer bay.  The outlet that the scale is plugged into should be properly grounded and have the correct voltage supply. …

67, 63 Scale Reports page 2: The 1 st line contains the report name and the page number (2 of 2.) The 2 nd line contains today’s date and the scale number of the scale that generated this report. The 3 rd line contains the number of times that the Z report has bee…