A.O. Smith SGE - 40 Installation, User And Service Manual

89, is Instruction manual SGE 86 S07 (blocking error) Open circuit from temperature sensor S 2 at the bottom of the tank. Sensor is not (correctly) connected Connect the sensor lead to J14 (ports 2 and 4) of the solar controller See the electrical diagram (17 " Appendices&quo…

78, Instruction manual SGE 75 is 12 Service program 12.1 Introduction The service program is used by the installation engineer or service and maintenance engineer for: • Displaying the water heater history • Displaying the error history • Displaying the water heater history • Disp…

82, Instruction manual SGE 79 is 12.10.6 Displaying contribution This option enables you to read out how much energy the solar heating system supplies. For this data to be displayed, the installation must be equipped with a Q/T sensor (12.10.5 " Setting the Q/T sensor"). Three values ar…

55, Filling 52 Instruction manual SGE 5 gis 5.3.2 Filling met glycol 1. Insert the hose of the glycol pump into the jerry can containing the glycol. 2. Connect the pump to the jerry can. 3. Connect the hose of the glycol pump to the inlet combination of the pump station. 4. Open the valve of the inlet …

40, Instruction manual SGE 37 is 3.11.5 Connecting a program-controlled pump Note The maximum power capacity for a pump regulated by the controller is 100W. 1. Connect neutral (N), live (L) and earth ( ) to terminals 13, 14 and 15 as indicated in the table (3.11.2 "Preparation"). 2. Fit the …

23, A.O. Smith SGE - 40 Installation 20 Instruction manual SGE 3 is 3.3.1 Air humidity and ambient temperature The boiler room must be frost-free, or be protected against frost. The table shows the ambient conditions that must be adhered to for correct functioning of the electronics present in the appliance to be guarant…