Fantech SHR series Installation, Operation And Maintenance Manual

6, 16 • Install the unit close to the outside wall on which the supply and exhaust hoods will be mounted. • Have a nearby power supply 120 Volts, 60Hz. • Have the possibility of mounting the unit to supporting beams. • Mount the unit as level as possible in order to allow proper conde…

7, 17 3 Push the hood into the opening. Attach the hood to the outside wall with mounting screws. Repeat the installation procedure for both the Supply and Exhaust hood. 2 Pull the insulated flexible duct through the opening until it is well extended and straight. Slide the duct’s i…

4, Fantech SHR series 14 15-min Timer - The 15-minute remote timer is typically installed in areas where contaminated such as moisture and odors, are produced. Simply push the button and the HRV / ERV will activate to high speed for 15 minutes. Up to 5 electronic timers can be installed throughout the building…

10, 20 Bedrooms Fresh Air Exhaust Air Central Control - optional Fresh air to living room Exhaust Bathroom 460 mm 18 00 m m HRV DUCTING FIFTH PORT UNITS (R) All SHR(D) / VHR / SER / VER Series R (1405R, 1505R, 2005R & 3005R) HRV / ERV’s have a fifth duct port on top (SHR(D)/SER) or side (V…

5, 15 OPERATION (CONT'D) OPTIONAL INTELLITEK CONTROL Note: All controls are low voltage. 18 to 24 gauge wire is recommended. EDF2 INTELLITEK MULTI- FUNCTION WALL CONTROL Control multiple functions of your Fantech SHR/VHR or SER/VER with one slimline wall control. Two wire connec…