CALORIQUE THERMOLAR THS-106 Installation And Operation Manual

5, INSTALLATION HEATING ELEMENTS 1. Attach heating elements to the tank sidewall using the adhesive backing provided. Hold the elements in position then, working around the tank, peel the release paper from them and press lightly into position. 2. Repeat step 1 for each heating element. …

7, INSTALLATION ELECTRICAL CONNECTIONS 1. Measure and record the resistance of each heating element. Record the measured resistances on the label on the back of the control unit face plate. 2. Route all wiring to the control unit as shown in the following figure. 3. Secure all wiring in p…

4, INSTALLATION CCiirrccuuiitt OOvveerrccuurrrreenntt PPrrootteeccttiioonn Fuse or circuit breaker rated for at least 120% of the system amperage rating. FFaauulltt PPrrootteeccttiioonn The power supply must include a fault detector suitable for equip- ment protection. This may be integral…

3, HHeeaattiinngg EElleemmeennttss Calorique Thermolar heating elements are factory assembled with an integral ground shield, adhesive backing and moisture-proof electrical connections. Width: 11 inches/280 mm Maximum Temperature: Do not expose any Thermolar heating element to tempera- tures in ex…

1, Thermolar ® Tank Temperature Maintenance System Installation & Operation Manual for Systems Employing THS-106 or THS-206 Electronic Controller. Precise, efficient temperature maintenance for all types of metal and plastic tanks. …

2, CALORIQUE THERMOLAR THS-106 INTRODUCTION The Calorique Thermolar® Tank Temperature Maintenance System is a low heat-density warming system designed to safely and efficiently maintain the contents temperature of any tank. Ideal for process control, adhesive storage (etc.) the THERMOLAR system provides uni- form heat tha…