Fei Bao F18-f Assembly Manual

8, 7 F E I B A O F 1 8 - f Everything needs to be very clean, especially the inside of the tanks. Depending on the kind of header tank you use, The BVM UAT as shown above should be installed at an approx. 45-degree angle to allow air bubbles to exit from the top fill line. You can als…

1, F E I B A O F 1 8 – f FEI BAO JETS F18-f Assembly Manual Written by Jeff DeCaluwe In collaboration with R/C Jet Models 1 …

7, F E I B A O F 1 8 - f  Attach Red air line to each retract cylinder so that when air is applied it will cause the gears to deploy. Use enough line to have the lines exit 1 foot as the previous door lines did before.  Repeat the previous again but use Purple air line on the retr…

4, 3 F E I B A O F 1 8 - f We start assembly in a sequence as: 1. Installing door hinges, doors and all air cylinders, for a minimal fee, the factory will install them all for you, which I believe is well worth every cent. 2. Pneumatic lines for doors, retracts, bra…

22, Fei Bao F18-f 21 F E I B A O F 1 8 - f 8: FRONT WHEEL SERVO & PULL-PULL LINKAGE  Install the nose gear steering servo with the hardware that is supplied with the servo  Use your hand pump to unlock the nose gear retract so it can move freely up and down. Insert the nose gear assembly …

24, 23 F E I B A O F 1 8 – f  If you notice all the stuff on the main tray, it has been placed on the outer edges to prevent the cockpit from touching them. The UP3, Receiver, Gyro and air failsafe are just under the main tray in front of the UAT on the new made tray. You can…