ECS CDC-TI Operation & User’s Manual

36, Chapter 3 CDC-TI USER MANUAL 32 Power Management Setup This page sets up some parameters for system power management operation. Resume By PME (Disabled) The system can be turned off with a software command. If you enable this item, the system can automatically resume if there is an incoming call on …

31, Chapter 3 CDC-TI USER MANUAL 27 About the Setup Utility The computer uses the latest “American Megatrends Inc. ” BIOS with support for Windows Plug and Play. The CMOS chip on the motherboard contains the ROM setup instructions for configuring the motherboard BIOS. The BIOS (Basic Input and …

13, Chapter 2 9 CDC-TI USER MANUAL The following illustration shows the location of the motherboard jumpers. Pin 1 is labeled. To avoid the system instability after clearing CMOS, we recommend users to enter the main BIOS setting page to “Load Default Settings” and then “Save and Exit Setup”.…

17, Chapter 2 13 CDC-TI USER MANUAL Follow these instructions to install a wireless card: 1 Remove a blanking plate from the system case, and insert the wireless card into the MINIPCIE slot rightwards, then tighten the two screws (Please refer to Picture 1). 2 Press the metal connector of the ca…

35, Chapter 3 CDC-TI USER MANUAL 31 Launch Storage OpROM (Enabled) Use this item to enable or disable the Storage OpROM. The Advanced menu items allow you to change the settings for the CPU and other system. Advanced Menu Launch PXE OpROM (Disabled) The item enables or disables launch PXE …