Basler Pioneer Operation & User’s Manual

191, Standard Features Basler pioneer 181 13.2 Black Level Adjusting the camera’s black level will result in an offset to the pixel values output from the camera. As mentioned in the "Functional Description" section of this manual, for readout purposes, the sensor used in the camera…

45, Basler Pioneer Software and Hardware Installation Basler pioneer 35 2.2.5.4 Installing a Software Component The procedure below describes how to install a Basler pylon software component that is not included in the current installation of Basler pylon software on your PC. You will have to install a Basler py…

73, Camera and Network Adapter IP Configuration Basler pioneer 63 Note When you configure an adapter to use a fixed address, there are some things that you must keep in mind:  If your PC has multiple network adapters, each adapter must be in a different subnet.  The recommended ran…

188, Standard Features 178 Basler pioneer . . If e.g. the piA640-210 gm/gc camera is set for a pixel data format that yields 8 bit effective pixel depth (Mono 8, YUV 4:2:2 Packed, YUV 4:2:2 (YUYV) Packed):  The Gain Raw All value can be set in a range from 0 to 500.  The Gain Raw Tap 1 valu…

214, Standard Features 204 Basler pioneer To load a saved configuration set or the default set from the camera’s non-volatile memory into the active set:  Set the User Set Selector to User Set 1, User Set 2, User Set 3, or Default.  Execute a User Set Load command to load the selected…

42, Software and Hardware Installation 32 Basler pioneer Go on to step 8. 8. Click on the Alternate Configuration tab. a. Make sure that the Automatic private IP address radio button is selected as shown below. b. Click the OK button on the Internet Protocol Properties window. c.…