Fiberstars JAZZ J400 Owner's Manual

3, 79-15217-00 REV. A www.fiberstars.com Page 3 of 7 Figure 1 Install fixture in a vertical pool or spa wall – not in floor. Failure to install the fixture properly could result in personal injury and/or property damage. Except when the fixt…

6, 79-15217-00 REV. A www.fiberstars.com Page 6 of 7 b. Using a small Phillips screwdriver, remove the two screws holding the lamp assembly and the three screws holding the lamp bracket assembly and hot mirror and place in a secure location, see Figure 3. Do not remove any screws other t…

2, 79-15217-00 REV. A www.fiberstars.com Page 2 of 7 CAREFULLY READ AND FOLLOW ALL SAFETY INSTRUCTIONS IN THIS MANUAL AND ON THE LIGHT AND ASSOCIATED EQUIPMENT. HAZARDOUS VOLTAGE Incorrectly installed equipment may fail, causing severe injury or property damage. Have a certified electricia…

4, 79-15217-00 REV. A www.fiberstars.com Page 4 of 7 4. Insert cord into the niche and place the lamp housing in the niche. Be sure that the locator tab on the bottom of the lamp housing is in the notch at the bottom of the niche. 5. Insert the top screw into top hole on niche and tight…

5, Fiberstars JAZZ J400 79-15217-00 REV. A www.fiberstars.com Page 5 of 7 C. SPECIAL NOTE FOR X-10 CONTROL The lowest possible signal that can make a module respond properly is 150mV. Please refer to the X-10 installation manual. Contact X10PRO for troubleshooting operation. D. WPC family of contro…