Beam SatDOCK RST980 Installation & User Manual

20, Beam SatDOCK RST980 RST980 INSTALLATION & USER MANUAL 20 Selecting a Location for the Microphone The hands-free directional microphone must be properly positioned in the vehicle to ensure optimum performance. When selecting a location for the microphone, consider these guidelines: ¾ Mount the m…

25, RST980 INSTALLATION & USER MANUAL 25 Mute Functionality & Privacy Mode Mute functionality: The mute function of the SatDOCK, allows the user to mute the uplink (MIC) audio to the 9505A handset whilst docked in the SatDOCK, by simply pressing the Mu…

29, RST980 INSTALLATION & USER MANUAL 29 Using the Line In/Out The Line In/Out pluggable screw-terminal allows interfacing to the vehicles’ existing communications system. The Line audio level of this interface is that of typical equipment being -10dBV, which is about 0.3V. Pin…

17, RST980 INSTALLATION & USER MANUAL 17 Installing Hands Free Interface Unit (HFI) In many vehicles, the best location for these units is on the floor or the rear vertical panel of the trunk compartment. Alternate locations include under the dashboard, under the front or rear seat, o…

40, RST980 INSTALLATION & USER MANUAL 40 A Ensure the signal strength is at 5 bars on the handheld terminal Check your location and for interference Keep in mind that on hands-free calls there may be background interference from environmental noise Remember all satellite network have a slig…

24, RST980 INSTALLATION & USER MANUAL 24 Antenna Operation Please note that earlier firmware versions of the 9505A handset may display a message prompting the user to rotate the antenna. To toggle between enabling / disabling this message when in the SatDOCK, us…