DAGE-MTI Excel Series Operation & User’s Manual

13, Automatic Camera Driver Installation There are two methods of automatic driver installation: a built in driver install within the Exponent software application, and the Windows Hardware Wizard. The Exponent software driver install method below is the preferred method and should provide a…

7, IEEE-1394 Card Installation (PC) An IEEE-1394 PCI bus card is included with each camera. Installing the 1394 PCI OHCI (Open Host Controller Interface) card is very similar to installing other PCI devices. Upon successful installation of the card, Windows Device Manager will have an “…

16, Dage Exponent Software Main Window MENU BAR TOOLBOX CAMERA NAME VIDEO WINDOW TOOLBARS STATUS BAR Menu Bar- Allows access to the various software & camera functions via drop down menus. • Camera- Shows and gives access to the cameras on the Firewire network. Sel…

6, DAGE-MTI Excel Series Installation Hardware Requirements The Excel cameras and the Exponent application program are designed to run on a PC with Windows XP ® (SP1 & SP2). Direct-X 9.0C will be installed during software installation if needed. Also Microsoft .NET version 1.1 may need to be insta…

45, A Windows Logo Testing Warning will appear, click “Continue Anyway”. The “Completing the Found New Hardware Update Wizard” window will appear, click “Finish” From within the Windows Device Manager (“Control Panel/System/Hardware/Device Manager”) the camera should n…

4, Introduction Excel Camera Hardware The DAGE-MTI Excel family of digital cameras are based upon the Kodak KAI series of interline transfer, progressive scan, CCD sensors. These high performance sensors have 7.4um square pixels with microlenses to provide high sensitivity and the large fu…