DAGE-MTI Investigater Operation & User’s Manual

13, DAGE-MTI Investigater Troubleshooting No Power Lights (Check or try the following): 1. InvestiGater Power Switch On? 2. External Power Supply Attached? 3. AC Power On? No Picture (Check or try the following): 1. InvestiGater in LIVE ? 2. Camera Power On? 3. InvestiGater/CCD100 C …

11, VIDEO IN The camera's video is placed into the InvestiGater either through this BNC or through the CAMERA connector. Care should be taken so as to not attempt to place two video sources into the InvestiGater at the same time. The video input signal is terminated into 75…

16, DAGE-MTI Inc. 701 N. Roeske Ave. Michigan City, IN 46360 (219) 872-5514 Fax: (219) 872-5559 E-mail: [email protected] http://www.dagemti.com 970292-01 8/13/02 …

8, Figure 5: Dage-MTI InvestiGater Rear Panel SGL/RUN This switch determines whether the gating process of the InvestiGater is a single event or an ongoing continuous affair. In the SGL mode, upon pressing the front panel ACT switch, one gating cycle is produced and the resu…

6, Operation Figure 4: Dage-MTI InvestiGater Front Panel The InvestiGater's front panel allows the user to switch between the stored image and the incoming LIVE image. The gating of the CCD camera is controlled through the front panel's GATE TIME switch and th…