Eiki LC-HDT700 Owner's Manual

22, This projector uses nominal input voltages of 100–240 V AC and it automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of…

92, ANALOG/ ANALOG OUT (Mini D-sub 15 pin) Appendix Configurations of Terminals 5 1 2 34 10 9 678 15 14 13 1 1 12 CONTROL PORT CONNECTOR (D-sub 9 pin) ----- R X D T X D ----- SG ----- ----- ----- Serial 1 2 3 4 5 6 7 8 Vcc - Data + Data Ground 1 2 3 4 USB CONNECTOR (Series B) -----9 RX…

84, Appendix On/OffDirect on Pointer Dot/Arrow/Finger Yes/No Management Remote control Projector 5 - 480 Min P-timer Count up Timer Start/Stop/Restart Count down Security Off Projector Remote control Key lock Off/On 1/On 2 PIN code change PIN code lock H Filter counter Yes/No Off/400H/700H/1000H Filte…

61, This function allows you to change brightness of the screen. Lamp control Setting Auto . . . . Brightness according to the input signal. Normal . . Normal brightness. Eco 1 . . . Lower brightness and decrease of fan speed. Lower brightness reduces the lamp power consumption and e…

77, Eiki LC-HDT700 Maintenance and Care The WARNING indicators show the state of the function which protects the projector. Check the state of the WARNING indicators and the POWER indicator to take proper maintenance. The projector is shut down and the WARNING TEMP. indicator is blinking red. When the tempe…

40, Computer Input Image adjust Menu Press the MENU button to display the On-Screen Menu. Use the Point ▲▼ buttons to select Image adjust and then press the Point ► or the SELECT button. 1 2 Use the Point ▲▼ buttons to select the desired item and then press the SELECT button to di…