Saeco Prime line Technical Service Manual

64, REV01 - Aug. 06 Ideas with Passion 7.8 Heater unit and multiway valve Loosen the screw securing the protection cas- ing (A) of the water tank, detach the base of the casing from the retainer by lifting it using a screw- driver and pulling it outwards. 11/22 Loosen the heater valv…

34, REV01 - Aug. 06 Ideas with Passion MENU 5.3 Ring test function Tmode L1 Inputs 1245679ABCDEFGH AROMA ESC UP DOWN During the first 3 seconds after start-up of the appliance (or on exit from standby mode) you can access test mode by pressing the keys in the sequence shown alongsi…

40, REV01 - Aug. 06 Ideas with Passion 18/20 PRIMEA Section 05 5.4.5 Ring system settings SYSTEM SETTING parameters Unit of measurement Settings range Default value SETTING Water heater temperature enabled °C 70 ... 150 130 Water heater temperature disabled °C 70 ... 150 115 Stea…

66, REV01 - Aug. 06 Ideas with Passion Remove the casing by removing screw (F) and withdraw the heater assembly from the casing. To separate the heaters from the plastic support, loosen the internal screw (G) to release the coffee heater and the screw highlighted in red to remove the tempera…

77, REV01 - Aug. 06 Ideas with Passion S= Replacement R= Service P= Cleaning D= Descaling C= Inspection *= Number of beverages dispensed. Components Task Reason Article Maintenance 5,000* 10,000* Casing, tanks, containers, power cable C C C Dirty, damaged See documentation (…

62, Saeco Prime line REV01 - Aug. 06 Ideas with Passion Refit the heater valve asm. (B) taking care to ensure that both seals (G) are present on the spout that is inserted in the pipe hole (D). Tighten the screws of the heater valve asm.. WARNING: ensure both screws are pushed fully down before …