electrifly reflection Instruction Manual

14, ❏ 5. Glue the aileron servo into a wing servo mount and glue the assembly into the bottom of the bottom wing with the output shaft toward the rear. ❏ 6. Cut a small hole in the fuselage to allow the elevator servo wire to pass through to the left side of the fuselage. pass the rudder servo w…

12, ❏ 12. Installing them from the bottom of the bottom wing, glue four supports into the slots in both sides of the top wing. Two of the supports are at the leading edge (for the landing gear) and two are at the trailing edge (for the wing struts). IMPORTANT: The holes in the supports m…

21, ❏ 7. Make sure any servo wiring does not interfere with other systems (servo arms, pushrods, etc.). ❏ 8. Place your name, address, AMA number and telephone number on your model. ❏ 9. If you wish to photograph your model, do so before your first flight. ❏ 10. Range check yo…

10, electrifly reflection ❏ 9. Install a Z-bend clevis (A1) into a clip hinge control horn (C1). Using the 3 x 145mm [1/8" x 5-11/16"] rudder post tube as a guide, glue three clip hinges and the clip hinge control horn to the rudder. ❏ 10. Snap the tailwheel (D4) into the tailwheel bracket (D5) and slid…

16, ❏ 2. Slide the motor mount block over the fuselage tube. Be certain the block is in the correct position so there will be down and right thrust. Glue the motor mount block onto the fuselage tube. ❏ 3. If using the included propeller, install the prop saver onto the gearbox shaft with the large…

1, WARRANTY Great Planes ® Model Manufacturing Co. guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This warranty does not cover any component parts damaged by use or modification. In no case shall Great Planes’ liability exceed the origina…