Dalsa P-2 Series Operation & User’s Manual

73, 73 Piranha2 User’s Manual GCP Screen Desctiption section 3.9 Setting Line Rate and Exposure Mode for details. Exposure Time: 197.950 uSec Current exposure time setting. Value is set with the set command. See section 3.9 Setting Line Rate and Exposure Mode for details. …

77, 77 Piranha2 User’s Manual Code Command Short Form Parameters Description Parameters: i = integer f = float t = tap selector s = string x1 = pixel start number x2= pixel end number []= optional parameter gain value of 0 sets the ca…

34, 34 Piranha2 User’s Manual 3.13 Setting Gains Optimizing gain in the analog domain allows you to achieve a better signal-to-noise ratio (dynamic range) than you would achieve by trying to optimize the gain in the digital domain. To set the analog gain mode, use the command: S…

36, Dalsa P-2 Series 36 Piranha2 User’s Manual The white light calibration is performed next to determine the multiplication factors required to bring each pixel to the required value (balance target) for flat, white output. Video output is set slightly above the brightest pixel (depending on offset …

45, 45 Piranha2 User’s Manual Figure 8: Piranha2, 2 tap models 6K 7 µm , ( ) ()4K10µm 2 TAP WITH F MOUNT 62. 3 89.2 Ø78.0 M72X0.75 CONTROL DATA 1 STATUS POWER 10.5 25.0 54.9(2X) 1k/2k (10 µm) 2 TAP WITH F-MOUNT ,( ) 4k (7 µm 89.2 54.9 (2X) 27.0 1 0.5 10.3 CONTROL/DATA 1 ST…

35, 35 Piranha2 User’s Manual To calibrate the analog gain: Syntax: cag t i Syntax Elements: t Tap selection. Allowable range is 1 to 4, or 0 for all taps. i Line average in a range dependent on the current camera data mode setting: 8-bit: 64 to 251 DN 10 bit: 256 to 1007 …