Dan Dugan Sound Design E Operation & User’s Manual

17, Dugan Model E User Guide Installation 17 3.3.2 Digital Adjust the console input gain trimmers so that talking signal levels at the sends are between -20 and 0 dBFS, and room noise at the sends is higher than -75 dBFS. Console input gains should be high enough so the level light…

38, Dugan Model E User Guide ASCII Remote Control 38 Unit Name This command queries or sets the unit’s name (15 character maximum). Query Set System Mute This command queries and sets the system (master) mute that affects all channels. 1 = mute all channels, 0 = unmute all channels:…

15, Dugan Model E User Guide Installation 15 Insert This is the normal way to connect the Model E using a mic-level signal. Patch the audio channels in the insert loop (send-return) of each console input strip. Check the insert jack wiring on your mixing board. If they are 1/4-in TR…

24, Dan Dugan Sound Design E Dugan Model E User Guide Operation 24 Figure 4-5 Insert points on most analog mixers are at point B To properly mute a channel: • Leave the console faders up, adjust levels while people are talking, and mute a mic by pressing the Dugan’s mute mode button. Enable the mic when needed…

30, Dugan Model E User Guide Web Control Panel 30 It is important to understand that the Speech System works by detecting the ratios of the levels between channels, not their absolute levels. The auto mix weight control is not a gate threshold! The following example explains how auto mix weight works…

11, Dugan Model E User Guide Quickstart 11 Step 3 Linking Multiple Units All linked units must be in analog audio I/O mode and use analog connections to the board because linking requires the digital I/O connectors. Up to eight Model Es (64 channels) can be linked into a single system…