Dateq Apollo Operation & User’s Manual

4, Mounting the Apollo The Apollo can be used as stand-alone or built-in (mounted). The housing fits in an opening of 448 x 337 x 115mm (W x H x D). See also the drawings below. When mounting reckon with the extending of the connectors on the backside of the Apollo. R E LIG HT SH OW M…

6, Connections MASTER L / R Electronically balanced master outputs for the left and right channel on XLR connectors. This type of output guarantees a perfect signal transport even when long audio cables are being used. These outputs are equipped with relays to prevent audible ‘blobs’ on connect…

7, Microphone / Line Channels (1 and 2) These two channels have been designed to connect microphones. They are equipped with an input selector, volume control, a 3-way tone control optimized for voice, crossfader routing selector and pre-fader listening. Mic / Line Input selector. Normally the Mic in…

9, BeatCompare The BeatCompare microprocessor is a tool for synchronised mixing music. The signal on the A and the B side of the crossfader is continuously searched for the presence of a beat. For this you have to set the signal level which is transferred to the crossfader at approxi…

2, Safety instructions 1 All safety instructions, warnings and operating instructions must be read first. 2 All warnings on the equipment must be heeded. 3 The operating instructions must be followed. 4 Keep the operating instructions for future reference. 5 The equipment may never be used in the immed…