Datsun 411 Series Service Manual

110, DATSUN The rubber bearing bushes or screw bushes may in time deteriorate and need renewing. Excessive side ways movement in either of these bearings would denote softening of the rubber bushes or screw bushes. The screwed bushes or the ball joints may develop excess free play due to wear of e…

49, ENGINE IGNITION TIMING DISTRIBUTOR Type Hitachi D411-53 Ignition timing standard 8° before top dead center at 600 r.p.m. Apparatus of automatic Governor type advance Advance starting 100-120 mm-Hg vacuum pressure Advance angle by 12°- 18° (Crankshaft) vacu…

63, ENGINE When a tester is to be used, make adjust- ments according to the following table. Conditions (Without load) Suitable Weight Ratio of Mixture Low Speed Running (600 r.p.m.) 70 ±2% High Speed Running (2,000 r.p.m.) 85 ±®% Engine Trouble Shooting Fig. 3 is intended …

130, Datsun 411 Series DATSUN Fig. 20 Measurement of Back Lash for the Drive Pinion & Ring Gear If it is necessary to use the bearing again at the time of repairing,the thickness of each shim of left & right must be reducted for 0.001"- 0.003" on the basis of 80% or 60% against standard preload in…

84, DATSUN -Nut Washer I to transmission to /lock I engine rear plate Bolt x rear extension Fig. 25 Transmission Case & Rear Extension Ring map, main drive ^ ear Bearing main Spacer main drive gea drive gear Ass'y pinion, Ass'y sleeve, speedometer s P« domet « I Pin…

101, DATSUN SECTIONAL VIEWS OF TRANSMISSION SELECT AND ADJUST THE END PLAY OF REVERSE GEAR IDLER SO AS TO FIT 0.05 — 0.15 mm BY PART No.32285-14600/1/2/3/ ADJUST THE END PLAY OF COUNTER GEAR SO AS TO FIT 0.05-0.15 mm BY PART No. 32225-14600/1/2/3/4 665 — SECTION C-C = 1.2-…