Belling GAS B Service Manual

37, INSTALLATION INSTRUCTIONS - 70CM Method 3: Housing unit with internal height 710mm or more Note: You will not need the 4 runners and 2 trims that are packed with the oven for this installation. 1. When installed in a typical 600mm deep built in housing unit, the false back shoul…

90, 12 H) IGNITION GENERATOR RELEASE CLIPS BY PUSHING GENTLY WITH A SCREWDRIVER TIP PULL THE IGNITION GENERATOR FROM THE REAR OF THE APPLIANCE I) HINGES REMOVE THE 2X SCREWS AS SHOWN AND PULL THE HINGES OUT OF THE FRONTFRAME WHEN REPLACING IT IS IMPORTANT THAT THE EXACT SAME HINGE IS REPLA…

32, INSTALLATION INSTRUCTIONS - 70CM Method 1: Without housing unit (between 2 base units) Shown with fixing kit  88: 8%9):; ?$:  8:   )9?  …

69, PRODUCT: BEL BI 90 G LPG AU Sta Built-in COLOUR: Stainless Steel CODE: 444440561 ISSUE: DATE: Ke y Product Product Descri p tion TCO Re p lace Date Q t y 073103212 CHASSIS bi 90 g 1 00358 603005600 FRONTFRAME 90bi mot 1…

81, Belling GAS B 3 1) REMOVING THE MAIN OVEN DOOR REMOVE THE 2 SCREWS FROM THE DOOR EXTRUSIONS AS SHOWN MOVE THE DOOR TO REST POSITION AND SLIDE THE DOOR UPWARDS OUT OF THE HINGES 2) REMOVING THE TOP OVEN DOOR REMOVE THE 2 SCREWS FROM THE DOOR EXTUSIONS AS SHOWN PUT THE DOOR IN THE REST POSITION AND PULL THE…

40, INSTALLATION INSTRUCTIONS Connect to gas supply 1. The inlet to the appliance is ISO 7 - Rp ½” internal thread situated towards the top right hand rear corner. 2. Fit the bayonet connection to the wall in the shaded area as shown. The shaded area shown is applicable to installa…