Gator ARV43M Instruction Manual

1, ARV43M Instruction Manual In terms of the wiring of the camera system, the Gator ARV43M can be electrically installed in 2 different ways, wired or wireless. We call this versatility Dual Tech. WIRELESS INSTALLATION: Wireless installation refers to the connection of the video signal to the…

2, WIRED INSTALLATION: The video signal is transferred from the camera to the monitor via an RCA cable that will need to be run from the boot through the passenger compartment to the monitors wired loom run under the dash. From there the power and video signals are sent directly to…

3, INSTALLING THE CAMERA ( Wired installation or Wireless) In most instances, the camera is best mounted above the vehicles license plate as shown here. Where this is not possible there are other camera combinations that will suit your individual application. When mounting the camera, make…

4, Gator ARV43M WIRELESS INSTALLATION. 1. Connect the RED wire of the wireless video transmitter to the wire that supplies power to the reversing light (this is the wire that is energized when the vehicle is put into reverse). Please measure the voltage on this wire to make sure that it is +12V when it i…

5, 3. Connect one end of the Supplied RCA Video lead to the RCA lead coming from the camera then run the RCA lead to the front under side of the driver side dash board (This is were the monitors loom will be located). To do this you will need to remove the rear seat to pass the cable into the cabin…