DeepSea Power & Light Wide-i SeaCam Operator's Manual

1, DEEPSEA POWER & LIGHT ® T: (858) 576-1261 F: (858) 576-0219 4033 Rufn Road San Diego, CA 92123- 1817 USA www.deepsea.com [email protected] Original Instruction - 1 Operator’s Manual REV 8/7/13 Wide-i SeaCam ® Record product serial number below as it appears on the nameplate. Seria…

2, Specication Overview * Specications subject to change without notice. 2 Wide-i SeaCam ® Operator’s Manual Dimensions Standard Connector MCBH4MP 1 = Ground 2 = Power 3 = Video 4 = Not Used Mechanical Specications Housing 6013-T 8 AL Port Optically Polished Glass Outer Diame…

3, Wide-i SeaCam ® Operator’s Manual 3 Table of Contents Specification Overview 2 Table of Contents 3 Safety Symbols 4 General Notes and Warnings 4 Pre & Post Dive Inspection …

4, DeepSea Power & Light Wide-i SeaCam Wide-i SeaCam ® Operator’s Manual 4 Safety Symbol In this operator’s manual and on the product, safety symbols are used to communicate important safety information. This section is provided to improve understanding of these symbols. This is the safety alert symbol. It is used to al…

5, Wide-i SeaCam ® Operator’s Manual 5 3. Plug the BNC connector on the topside of the cable into the monitor or VCR video-in jack (a BNC-to-RCA adapter may be required by the monitor/VCR in use). 4. Lubricate the camera bulkhead connector with an appropriate silicone lubricant (spray…

6, Wide-i SeaCam ® Operator’s Manual 6 RMA Procedure for Repair Should it be necessary to return your camera to the factory, follow the procedure for the Flooded Camera Repair above, and by leaving the connector partially unscrewed. For warranty and non-warranty repairs please con…