inFusion 800 Installation, Operation And Maintenance Manual

6, 6 2. Lubricate the distributor tube O-ring seal and tank O-ring seal. Install the upper basket on the bot- tom of the valve. Place the main control valve on tank. Note: Only use silicone lubricant. Turn the valve clockwise until it is hand tight. Give it a couple taps wit…

19, 19 LIMITED WARRANTY US Water Systems, Inc. warrants the Infusion system as follows: The Tanks are warranted to be free of defects in materials and workmanship for life from the date of original installation. The Valve and Electronics are warranted to be free of def…

7, inFusion 800 7 Installation Instructions Place the Infusion tank where you want to install the unit making sure the unit is level and on a firm base. During cold weather, the installer should warm the valve to room temperature before operating. All plumbing should be done in accordance with l…

10, 10 Installation, Operation and Maintenance Manual 169-ISF-1, 169-ISF-2, 169-ISF-3 & 169-ISF-4 6. Now connect a piece of the tubing to the chemical pump inlet. The inlet will have and arrow point up. Make sure to leave enough tubing to reach the peroxide container. …

4, 4 System Overview Installation, Operation and Maintenance Manual 169-ISF-1, 169-ISF-2, 169-ISF-3 & 169-ISF-4 …

2, 2 Installation, Operation and Maintenance Manual 169-ISF-1, 169-ISF-2, 169-ISF-3 & 169-ISF-4 Table of Contents Introduction and Benefits ........................................................................ 3 System Overview ...........................................…