Maktec MT605 Manual, Technical Information

4, [3] DISASSEMBLY/ASSEMBLY [3]-2. Spindle and Helical Gear DISASSEMBLING ASSEMBLING (3) Remove Helical gear 35 and Ball bearing 6902ZZ (Fig. 5). Note: 1. Use new Ring spring 13 after mounting Ball bearing 6902ZZ if it is deformed. 2. Make sure to fix Helical gear 35 at corr…

6, Circuit diagram Fig. D-1 Products with Reverse Switch (Model MT606, MT607) White Switch Noise Suppressor Field Choke Coil Housing L side With Equipment of Radio Interference Suppression Without Equipment of Radio Interference Suppression Housing R side Choke coil Brush Holder Orange P…

3, [3] DISASSEMBLY/ASSEMBLY [3]-1. Drill Chuck DISASSEMBLING [3]-2. Spindle and Helical Gear DISASSEMBLING ASSEMBLING (2) Remove Drill chuck by using 1R223, 1R224 and Bit adapter (Fig. 3). Note: Preset fastening torque of 1R223 to 25.52 - 29.42 N.m and fasten Drill chuck by turning 1R223 clockwise. …

9, Rear side Field Side window Housing R side Housing L side Wiring of Field lead wires (orange), (purple) to Brush holder Fig. D-2A Fig. D-3A Brush holder on back side Brush holder on Switch side Put slacked Lead wire (purple) in these places. Housing L Brush Holder Put Insulated connector …

1, Maktec MT605 CONCEPT AND MAIN APPLICATIONS P 1/  Standard equipment Specification Continuous Rating (W) Voltage (V) Cycle (Hz) Input Output Max. Output (W) 110 120 220 230 240 4.3 4.0 2.2 2.1 2.0 50/60 50/60 50/60 50/60 50/60 450 ---- 450 450 450 230 230 230 230 230 350 350 350 350 350 Current…