iRobot ROOMBA SCHEDULER Service Manual

11, 11 Record the ‘Power Supply Code’ Appendix C 13: Test Virtual Wall (if applicable) Test returned Virtual Wall with charged batteries o Clean Virtual Wall (IR emitter) o Check power light (if blinking then batteries are low) o…

71, 71 Appendix L: Built-in-Test Toolbox kits These stripped down versions make it easier to attach and perform Built-in-Tests while fixing Roombas. Source Toolbox version Bumper connector UI Connector …

60, 60 15 Plug-in Charger Precharge Plug in the plug-in charger. Plug-in charger available. Pre-charge current OK. 16 Plug-in Charger On Plug-in charger available. Charge current OK. 17 Plug-in Charger Trickle Plug-in charger av…

12, 12 17: Monthly Data Report to iRobot Send monthly report to iRobot ([email protected]) 1. A zipped up file of monthly Built-in-Test output files. The zip file should have a name format of YYYYMM_RoombaBiT_##.csv wher…

84, 84 Appendix O: Roomba Engineering Changes Gearbox Housing 2004-11-07 Change outboard housing from POM to GF NYLON which has a higher melting temperature. Serial Port Housing 2004-11-15 Bevel the metal housing to reduce shorting between the…

15, iRobot ROOMBA SCHEDULER 15 1 Lift outer bumper slowly (it is attached by a connector) 2 Angle the bumper outward and carefully disconnect connector from outer bumper 3 Lift top shell slowly (it is attached by a connector). Carefully disconnect the co…