Marantec EX-2005 Installation And Operating Instructions Manual

29, 29 1 2 10 7 5 3 4 Header End Powerhead End 9 8 Item Part # Description 1. ——— Rail 2. 8030339 Sprocket holder assembly 3. 8030432 Roller holder with tension bolt assembly 4. 8008503 Rail end-stop 5. 8030234 Chain connector 6. ——— Chain with position tab Item Part # Descr…

34, 34 De-activate 'vacation' lock on 3-function wall control or by briefly pressing button on operator. Operator is in electronic 'vacation' lockTransmitter command does not respond but wall control does (LED 8 on, LED 7 flashes) Check door.Door too sluggish. Have operator …

20, Marantec EX-2005 20 Page 21 Add beam break (photo eye safety system) Set maximum OPENING force Set maximum CLOSING force Set offset learned power limit (sensitivity) Set "opener speed" ANCED SETTINGS Advice: Changes in the programming levels of extended opener functions should be carried out by…

18, 18 Set door OPEN position Set door CLOSED position Program hand transmitter S ET DOOR OPENPOSITION 1. Press for 2 seconds until LED blinks and all others are illuminated. 2. To move the garage door to desired fully OPEN position press & hold the until desired DOOR OPEN position is …

25, 25 S ET EXTERNAL SIGNAL LIGHTS (/) 1. LED blinks and all others are illuminated. 2. Use or to set the signal light function LED blinks:external signal will be illuminated LED illuminated: external signal will blink 3. Press to store and go to Menu 4. S ET OPENER LIGHTING (/) 1. LED blinks and …

8, 8 ■ Mark pilot holes location on header thr ough holes where lag screws will be inserted. IMPORTANT: See Fig. 10 for which header bracket holes to use. ■ Drill 3/16" pilot holes into header, and install bracket with lag scr ews (5/16 x 1-5/8”) provided. ■ Tighten lag screws …