BK Precision 9115 Programming Manual

19, readings. Command syntax: FETCh:VOLTage? Return parameter: <NRf> Return parameter unit: V MEASure[:SCALar]:CURRent[:DC]? This command is used to read the actual current. Command syntax: MEASure[:SCALar]:CURRent[:DC]? Parameter: None Return parameter: <NRf> Return par…

13, (4) Eeprom failure (5) RST checksum failed (10) RAM selftest failed (40) Flash write failed (41) Flash erase failed (213) RS-232 buffer overrun (216) RS-232 receiver framing (217) RS-232 receiver parity (218) RS-232 receiver overrun (220) Front panel uart overrun (22…

12, 2.3 SYSTEM Subsystem SYSTem:ERRor? This command is used to read the error code and the error information. Command syntax: SYST:ERR? Parameter: None Returned parameter: <NR1>,<SRD> The following is the error code and the definition: (101) Too m…

22, Parameter: Parameter1 represents the number of step to be edited.Parameter2 is the current (MIN~MAX). Query syntax: SEQuence:CURRent? <NR1> Return parameter: MIN~MAX SEQuence:WIDTh This command is used to edit the width of specified step of the sequence file . Command syntax: S…

15, This command is used to set the slave machine’s address when communicating through RS485 interface. Command syntax: ADDRess <NR1> Parameters: 0-31 2.4 TRIGGER Subsystem TRIGger[:IMMediate] This command is used to create a trigger signal. It will give a trigger signal in B…

5, BK Precision 9115 RS-485 For multi-unit configuration and control, the male DB-9 interface labeled RS-485 in the rear panel is used. The below illustrates the connection pins and description. Note: Pin 1 is used as the B pin (+) (non-inverting). Pin 5 is used as the A …