Black BLK-IPS103 Operation & User’s Manual

18, 16 www.digiop.com SECTION 2: INSTALLATION AND SETUP In the example shown above, the message “Reply from 192.168.1.200: ..” indicates that your PC can reach the device with that IP address, and that address is in use (i.e., you cannot use it for your camera). d. Since the ping test of the IP…

12, 10 www.digiop.com SECTION 2: INSTALLATION AND SETUP 2.4.6 LAN and power connections Your camera can be powered locally with a 12 V DC adapter or with Power over Ethernet (PoE, see Appendix B). If you are using PoE, you do not need to attach a power adapter to the camera. 1. Attach a L…

5, Black BLK-IPS103 3H.264 Network IP Camera User Manual SECTION 1: FEATURES Analog video out Reset USB 9-pin terminal block DC jack adapter cable connector Micro SD card slot LAN 4-pin connector for Auto Iris Back connectors and controls Reset – For restarting the camera, or resetting the camera …

11, 9H.264 Network IP Camera User Manual SECTION 2: INSTALLATION AND SETUP Relay type alarm wiring schematic To connect an alarm reporting device to the camera, strip 1/4” of insulation from the alarm wires and insert them into the terminal block in the DO pin locations shown above. T…

20, 18 www.digiop.com SECTION 2: INSTALLATION AND SETUP d. Click SETUP. A Login window will open. 5. In the Login window, enter the ID and PW (password) for your camera, then click Login. The default administrator ID and PW are root and pass. After entering the ID and PW, the IP Setup window closes.…

15, 13H.264 Network IP Camera User Manual SECTION 2: INSTALLATION AND SETUP 4. In the IP Setup window, click the Static option bullet to select this option. Static Option If you have other compatible, network settings you want to apply to the device, enter them in the appropriate l…