A&D AD-4408A Instruction Manual

39, A&D AD-4408A Page 37 AD-4408A 10. Maintenance 10.1. Error Messages If an error message is displayed, refer to the chart below to take proper measures. Error message Cause Remedy C5 err Program checksum error Repair is required. ad err Data can not be acquired from the A/D converte…

35, Page 33 AD-4408A 8.3. Standard Serial Output (Cl f) Function No. Parameter or Setting range Function Description Default value Cl f01 1 to 5 Output data 1: Displayed weight 2: Gross weight 3: Net weight 4: Tare weight 5: Gross/Net/Tare 1 Cl f02 1 to …

38, AD-4408A Page 36 9.1.3. Data transfer mode Three data transfer modes are available; stream, auto printing and manual printing. Stream mode Transmits data in sync with the display update rate. If the indicator can not catch up with the update rate because of the baud rate, the t…

24, AD-4408A Page 22 7.3. Calibration-Related Functions (Calf) Step 1 Press the ON/OFF key to turn the indicator ON (weighing mode) if it is in the OFF mode. Remove the CAL key cover and press the CAL key. Cal is displayed to indicate that the indicator enters the calibration mode. S…

18, AD-4408A Page 16 6.1.3. Tare Tare is a function to store the gross weight as the tare value and set the net weight to zero. The tare weight is stored in the non-volatile memory and is maintained, even if the power is disconnected. Clearing the tare weight is performed using the F k…

10, AD-4408A Page 8 4. Description of Each Part 4.1. Front Panel Fig.1 Front panel Displays No. Name Description 1 Main display Displays the weight value, setting values, error messages, etc. 2 ZERO Turns ON when the weight value is in the cent…