MaxPower T Series Operation & User’s Manual

10, Use the test function to check both the operation of the UPS and the condition of the battery. In AC operating mode,the level indicator will show the actual load connected to this UPS normally.Press and hold the "Test" switch on the front panel for more than 2 seconds,t…

19, 4.Service and Maintenance * Use dry soft cloths to clean the front panel and plastic parts. * Do not use any detergent that contains alcoholic ingredient. * The expected lifetime of the battery is around 3-5 years. Improper operation or harsh environment will reduce the actua…

4, Table Of Contents Table Of Contents Important Safety Instructions 1. Introduction 1.1 System Description 1.2 Features 2. Installation and Operating Instructions 2.1 Unpacking & Inspection 2.2 Overview 2.3 Installation 2.4 Operation and Functional Test 2.5 Man…

15, NOTE LED Code Explain =Continuously Lit LED Code Explain = 1 Flash Every 0.1 Seconds =OFF Status Battery Capacity Indicators LED5 LED6 LED4 LED3 LED2LED1 Buzzer 1 Beep / 4 Seconds 1 Beep / 4 Seconds 1 Beep / 4 Second 1 Beep / 1 Second Operating Status Battery capacity=100% Battery…

14, MaxPower T Series 2.6.4.4 Output Voltage Setting Press the “ Test / Silence “switch to select the UPS output voltage setting mode. Selection output voltage indicator -Inverter LED light up Press the main switch “ " to select output voltage. LED3/4 Off (Ignore LED1,LED2,LED5) O…

8, 2.3 Installation Before installation, please read and understand the following instructions: Placement The UPS must be installed in a protected environment away from heat-emitting appliances such as a radiator or heater. Do not install this product where excessive moisture is present. Ventila…