Century Helicopter Products Predator 60 Instruction Manual

13, The main rotor grips will accept rotor blades that have a root thickness that is from 12mm to 18mm and have a 5mm hole. Carbon Rotortech and wooden Aerotech blades are designed for 5mm blades bolts. #HW6001 M5x35 Shoulder Socket Screw x 2 & M5 Locknut x 2 Assemble the landing skids onto t…

12, Century Helicopter Products Predator 60 Install throttle servo to the right side frames. Attach the short ball with M2 thread to the carburetor lever arm with M2 nut and the short steel ball to the top side of the servo arm at 13.5mm. Ensure the 90 degree angle from the pushrod to the servo and carburetor arm for linear setup at midst…

9, 17mm Standoff x 4 Attach the X Frame to the lower side frames first using M3x8 Socket screws and locknuts at the lower hole on a flat surface. Attach to the upper frames with M3x25 Socket screws, apply threadlock to the holes on the upper side frames. #HW6115A Rear Lower Frames #HW6117 Rear X …

18, Assemble the support bridge with M3 hardware. Press each side onto the support strut and secure with the cable tie wraps provided. Cable Tie x 4 SE & Max 90 only. #HI6082 Tail Support Bridge M3x15 Socket Screw, M3x8 Flat Washer x 2 & M3 Locknut Slide the two tail pushrod clamp…

5, Install the engine into the mount using the correct number of shims and ensure that the engine is centered in the mount. Use locktight on the M4 socket screws. Engine centered in engine mount. If a governor is planned to be installed, install the magnets into the holes already molded int…

3, #HI6160 Rotor Head Block #HI6181 Head Damping O-Rings Press in the damping o-rings into the rotor head block. Lubricate with light oil. #CN2215A Silver Head Button Bond the threaded stud into the head button using permanent locktight then apply more permanent locktight and bond int…