Embedded LPC3250 Operation & User’s Manual

30, LPC3250 Developer’s Kit - User’s Guide Page 30 Copyright 2011 © Embedded Artists AB Figure 7 – QVGA Base Board USB Device Fix of R100 Change R100 value by connecting a 1K resistor between the VBUS pin of the USB Host connector (J28) and the pin list, as …

15, LPC3250 Developer’s Kit - User’s Guide Page 15 Copyright 2011 © Embedded Artists AB EMC_BLS2 EMC_BLS3 EMC_CKE1 EMC_CLKIN EMC_DQM2 EMC_DQM3 EMC_DYCS1_N No. These signals are not used and not available. KEY_COL0 / ENET_TX_CLK KEY_ROW0 / ENET_TX_ER …

22, Embedded LPC3250 LPC3250 Developer’s Kit - User’s Guide Page 22 Copyright 2010 © Embedded Artists AB 101 GND GND 102 GND GND 103 NC I2S1TX_CLK 104 NC I2S1TX_SDA 105 NC I2S1TX_WS 106 NC P0.0 107 NC P0.1 108 …

37, LPC3250 Developer’s Kit - User’s Guide Page 37 Copyright 2011 © Embedded Artists AB Figure 15 – S1L loader up and running The S1L loader will initialize the board, such as clocks and external memory and then start a console where you can give input commands to t…

28, LPC3250 Developer’s Kit - User’s Guide Page 28 Copyright 2011 © Embedded Artists AB 4.5 Important Components The figure below illustrates the position on the QVGA Base Board for some important components in the design. Figure 5 – QVGA Base…

21, LPC3250 Developer’s Kit - User’s Guide Page 21 Copyright 2010 © Embedded Artists AB 70 P0.23 AIN0 Can be connected to accelerometer, X-axis 71 P0.24 AIN1 Can be connected to accelerometer, Y-axis 72 P0.25 AIN2 Can be connected to accele…