KEPCO KLP SERIES Manual, Klp Series

37, KEPCO KLP SERIES KLP-HV 070312 2-13 2.7.7.1 LOAD SHARING When operating two or more power supplies in parallel, either for capacity or redundancy, it is desirable to distribute the load equally among all of the power supplies in order to improve per- formance, reduce stress and increase reliabilit…

47, KLP070312 3-7 • Storage of User-programmed Active Settings (Save/Recall). • User-determined output Sequences. • External Triggers: VOLT:TRIG and CURR:TRIG values • Sequences programmed using LIST commands. To define a virtual model, proceed as follows. 1. If the status display shows SET, …

43, KLP070312 3-3 NOTE: A minimum programmed current is required to ensure proper operation of the power supply under all load conditions. Programmed current is automatically set to be at least the minimum current (actual value depends on model, see Table 1-2). • Since the output is off, Constant Vo…

75, KLP070312 3-35 If rINH is set to be active for low, an open condition at pin 8 causes the output state to default to ON and the output will go to the levels programmed on Vref and Cref without warning. If rINH is set to be active for high, an open condition at pin 8 causes the output to rem…

58, 3-18 KLP070312 3.2.16.3 SYSTEM CONFIGURATION FUNCTIONS The system configuration functions allow the user to determine 1) whether the Remote Inhibit signal is an active TTL high or low and 2) how the unit recovers from a fault. The unit password (see PAR. 3.2.7) is required to change these f…

26, 2-2 KLP-HV 070312 2.2.2 REAR PANEL CONNECTORS AND SWITCHES. Refer to Figure 2-2 and Tables 2-2 through 2-7. DC AMPERES display Four-digit LED display that shows current settings: a. Shows actual output current (PAR.3.2.9). b. Shows current set point or overcurrent limit when function selected …