Cheetah CL-180 Instruction Manual

2, High Power: True 153.6 W/S GN 160 (ISO200 at 10ft with standard reflector). Approx. 28 mm flash coverage when operating on a camera with the standard reflector. Bare bulb: Provides even 360 degree illumination Precise Output: Adjusting from 1/128 to full power in 1/3 stop increments Good Portab…

5, - 07 - - 08 - When “OF” is shown on the LCD display, it means no flash output and flash firing is turned off. 3. M Mode: Manual Mode Press MODE Selection Button (17) to enter M mode. In this mode, you can set the flash unit onto your camera hot shoe or your trigger hot shoe for firing. …

1, Instruction Manual C L-1 80 Cheetah light LLC. www.cheetahstand.com [email protected] (214)734-1198 …

4, Cheetah CL-180 - 05 - - 06 - 3. Rotate Accessory Locking Ring (2) clockwise to lock it up. Do not over-tighten. Attaching Flash Tube 1. Remove the reflector or other accessories from the flash head. 2. Match the red dot on the base of the flash tube with the red dot in the Tube Socket (4). Push the …

7, - 11 - Maintenance Shut down the device immediately should abnormal operation be detected. Avoid sudden impacts and the lamp should be dedusted regularly. It is normal for the flash tube to be warm when in use. Avoid continuous flashes if unnecessary. Maintenance of the flash must be perform…