Chevrolet Tahoe, Suburban 2007 Manual, Service Information

6, Chevrolet Tahoe, Suburban 2007 2. Adjust the "C" pillar striker up or down. Refer to the illustration above. 3. Adjust the "B" pillar striker up or down. Refer to the illustration above. Page 6 of 13 Service Information 4/9/2007 http://service.gm.com/servlets/BlobShtml?ShtmlFile=19…

11, 3. Replace the striker. Refer to the illustration above. 4. Align hardware and seat all fasteners. Refer to the illustration above. Condition The power sliding door reverses after making contact with the pads and plungers. Cause Visually inspect the pads and plungers for alig…

2, First verify that the door is flush to the rear quarter panel or inwards 1 to 2mm (0.039 to 0.078in). Bend the primary weatherstrip flange 1/8inch outboard above and below the rear striker. Refer to the illustration above. Condition The power side door reverses prior to making conta…

8, 6. Rotate the lower hinge arm for proper clearance. Refer to the illustration above. 7. Align and seat any hardware as necessary. Refer to the illustration above. Condition The power sliding side door starts to close then reopens. Cause 1. Inspect the "C" pil…

13, assembly being damaged. U.S.A. Dealer Training Information To access the training TECHAssist on this topic, take the following path at the GM Training Website: 1. After logging into the gmtraining.com website, choose the link on the left side of the page titled "Service Know-How/TECHAs…

4, 4. Inspect the pin and pocket alignment. Refer to the illustration above. 5. Inspect the lower arm clearance to the track. Refer to the illustration above. Page 4 of 13 Service Information 4/9/2007 http://service.gm.com/servlets/BlobShtml?ShtmlFile=1933131&a…