AGFA SnapScan Owner's Manual

36, Appendix A — Using the transparency option 36 6. Lower the transparency option. 7. Connect the male 15-pin connector of the transparency option to the female 15-pin connector at the rear of the scanner. Secure the connector by tightening its retaining screws. …

8, Chapter 1 — Preparing the scanner 8 Relocking the scanner If you need to transport the scanner over long distances, you should first relock it. This will protect the scanner’s optical assembly from possible damage. 1. Place the scanner on a horizontal, flat surface and pull it…

6, Chapter 1 — Preparing the scanner 6 Chapter 1 — Preparing the scanner This chapter assists you in preparing your SnapScan for installation. Unpacking the scanner Unlocking the scanner Relocking the scanner Taking a closer look Performing a power-on test Unpacking the scanner 1. Open the …

14, AGFA SnapScan Chapter 2 — Installing the scanner 14 Precautions For your own safety and that of your equipment, respect conscientiously the environmental requirements (see the above section) and always take the following precautions: Caution: For the reason of safety, besides the personal maintenan…

10, Chapter 1 — Preparing the scanner 10 1. glass plate 2. adjustable document cover 3. rulers 4. power indicator (the right green one) 5. info indicator (the left green one) 6. power switch 1. power connector 2. 25-pin SCSI connector 3. 50-pin SCSI connector 4. female 15-pin connector (fo…