Kidde PI9010 Operation & User’s Manual

4, Kidde PI9010 of the room.” NFPA 72 states: “A row of detectors shall be spaced and located within 3 ft (0.9m) of the peak of the ceiling measured horizontally” (see figure 2). • Install Smoke Alarms on tray-shaped ceilings (coffered ceilings) on the highest portion of the ceiling …

8, LED INDICATOR: This smoke alarm is equipped with a red LED indicator. The red LED is located under the test button and has several modes of operation. Standby Condition: The red LED will flash every 45 seconds to indicate that the smoke alarm is operating properly. Alarm…

11, • AC powered alarms (without battery backup) will not operate if the AC power has been cut off, such as by an electrical fire or an open fuse. • Smoke alarms must be tested regularly to make sure the batter- ies and the alarm circuits are in good operating condition. • Smoke alarms cannot…

10, NOTE: WEEKLY TESTING IS REQUIRED. WARNING!! USE ONLY THE BATTERIES SPECIFIED. USE OF DIFFERENT BATTERIES MAY HAVE A DETRIMENTAL EFFECT ON THE SMOKE ALARM. CLEANING YOUR ALARM YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR To clean your alarm, remove it from the mounting bracket as outlined…

1, For your convenience, write down the following information. If you call our Consumer Hotline, these are the first questions you will be asked. 9 Volt Battery Operated Photoelectric/Ionization Smoke Alarm with “HUSH” Control to temporarily silence nuisance alarms. Thank you fo…