Endless Pools Pools Installation Instructions Manual

1, Fully Aboveground Installations Partially In-Ground Installations Fully In-Ground Installations INSTALLATION INSTRUCTIONS …

16, Endless Pools Pools 28. Optional Deeper Platform Sometimes customers desire a deeper pool completely above- ground without excavation. This can be done by constructing a wooden platform using a drawing supplied by Endless Pools, Inc. This system is described in Tech Bulletin #14. This solution only applies to pl…

8, 6.Assembly of Pool Panels with a Deeper Pool When the deeper pool option has been selected, tension straps cannot be used. The anchor bolts provided with every kit must be used for these installations. They secure the panels to the concrete through the holes in the bottom flanges of the panels. Se…

14, before installing the liner. See Figure 18.2. The hole for suction from the pool for the jets should be cut 4" below the three inline thru-walls on the front panel. If the pool is located outdoors where freezing is an issue, care must be taken with the jet sys- tem plumbing. The freeze c…

5, top 24" of the pool panel for access both during and after installa- tion. Only 8" of clearance is required for the bottom 18" of the front panel and 7" of clearance is required for the other 3 sides of the pool — disregarding for the moment the requirements for access…

10, of the channels to keep the whole system level. See Figure 8.3. At the 4 corners, the short mitered pieces of liner hanger rest on 4 triangular inside corner supports. Once the entire system is laid out satisfactorily secure it down to the top flange through the pre-drilled holes in the liner ha…