Dialogic Eiconcard Family Installation Manual

19, Eiconcard™ Family Installation Guide page 19 Status Lights Eiconcard S91 S/T and S91 V2 ISDN D-channel status The D-channel controls the link to your ISDN service provider. Off.........The line is not active. The cable may not be connected. Blinking ..The line is active, but a link canno…

32, VHSI port specifications page 32 VHSI—V.36/RS-449 connections The wiring diagram in Figure 10 shows the connections required to construct a VHSI—V.36/RS-449 cable. For additional information required to construct your own cables, see “Cable construction information” on page 22. Fig…

18, Status lights Eiconcard C90, C91 S/T, C91 V2, and C91 PCIe LP page 18 Status lights Eiconcard C90, C91 S/T, C91 V2, and C91 PCIe LP ISDN D-channel Status (Eiconcard C91 S/T, C91 V2, and C91 PCIe LP only) The D-channel controls the link to your ISDN service provider. Off...........The line is …

41, Dialogic Eiconcard Family Eiconcard™ Family Installation Guide page 41 International regulatory information Regulatory information for the USA WARNING. Changes or modifications to this unit not expressly approved by Dialogic Corporation could void the user's authority to operate the equipment. Declar…

39, Eiconcard™ Family Installation Guide page 39 Technical specifications Eiconcard S series Technical data Hardware installation • Automatic configuration of interrupt request level setting and I/O address •32-bit I/O access Performance • 2 Mbps full duplex per physical VHSI po…

38, Technical specifications Eiconcard C series page 38 Power Requirements Note The Eiconcard C91 PCIe LP does not use 3.3V power and always draws less than 10W from the bus connector supply. Power Consumption Warning: Ensure that the power supply will not be overloaded. Maximum power consumpti…