Digi-IT DIS-4000 Operation & User’s Manual

44, Event recording Select the record mode by checking a box next to By EVENT. Select SCHEDULE SETUP Select one of the recording modes (Sensor, Motion, Sen+Motn, and Continuous). Fill in the schedule table according to the desired time and camera channel. 44 Sensor Motion Sensor & Motion Cont…

38, To deactivate all sensors: Right-click on the screen to select ALARM CLEAR, and then select ALARM ALL from the sub-menu. Confirm by selecting the tick button (√). To use the audio source from the camera site Using the front panel: Press the AUDIO button. Set the audio chann…

100, Appendix E - User account and menu access level Menus and operations you can access vary according to user levels. Refer to the table below. User Accounts On the device Viewer Playback Live mode control Operator All Viewer accesses Search PTZ control Admin All accesses and operati…

40, Select a camera number from the drop-down list. Select desired cameras and apply the same settings to them. Select one of the recording modes. Fill in the schedule table according to the desired day and time. Note i Before creating a schedule, settings for motion, sensor, and alarm should be don…

31, Digi-IT DIS-4000 - BUZZER Check a box to allow the device to make an alert sound for each condition as below. Panel Key: Allows the device to beep for each key pressing on the front panel. Video Loss: Allows the device to give a warning sound in case the video input is lost. Motion Event: Allows the d…

70, 2) Add Group : When you use “Multi-Channel”, you can make a grouping for the desired server and cameras which you want to connect by remote surveillance program. When you click “ Add Group”, you can see following window and make your own group table out of the open server and cam…